Quote:
Originally Posted by billbo911
All our shooter wheels are Banebots .5" hex bore, 2 7/8" dia. The thin ones are .4" wide and the thicker are .8" wide.
We use a combination of 3 .4" thick, or 1 .8" and a .4". Either way, the total height is 1.2".
The only real issues we have is they like to creep down the shafts. So, spacers help a lot.
|
We were using 1 .8" thick wheel per motor (for a 2 wheel linear shooter). Did you notice using a single wheel caused the frisbee to not fully catch on the second wheel in the shooter? (trying to see if thickness is the cause of our shooting problem)