[MagiChau]

Originally Posted by sg999

The rules (R71) say that the jumper needs to be in the position to read the battery value on the analog breakout. However, this means we can't get readings from the potentiometers we have going into the analog breakout (right?). Therefore, we need to have 2 analog modules in the cRio, correct? Or is there some way to get both battery level and read from analog sensors from one analog breakout?

there are three pins parallel to the board itself off to the side of where you plug in your sensorscloser to analog channel 8 as indicated on the blue guard. You use the jumper on the two pins closest to the outside edge of the breakout board to get battery voltage.