Quote:
Originally Posted by dcarr
The official measurements dictate 30" to the center of the bar, right? So in fact, this was only 0.625" out of range if I understand correctly. Still not too bad.
|
30" to the center minus a 3/4" radius is 29-1/4" to the bottom of the bar, so it was low by 5/8".
Quote:
Section 2.1 Overview
Fit and tolerance on large assemblies (e.g. the LOW GOALS) are ensured only to within ¼ in.
|
That would be 3/8" out of the tolerance range.