14-03-2013, 00:21
|
 |
 |
#StickToTheStratisQuo
AKA: Gregor Browning
no team
Team Role: College Student
|
|
Join Date: Jan 2012
Rookie Year: 2012
Location: Kingston, Ontario, Canada
Posts: 2,447
|
|
|
Re: How is 54" size limit being inspected?
Quote:
Originally Posted by Grim Tuesday
This is not the correct way to check. Our robot (see signature) is very close to being over the 54" limit, I think we were within about 1/2 an inch. The maximum point method will pass illegal robots. See the below picture for an explanation:
http://i.imgur.com/pDNlj09.jpg
At Fingerlakes, after an Inspector tried this method, we informed him why it was wrong and they pulled out a prinout of a 54" circle, which they projected upwards with an ruler. This seems like the correct method to use. |
Agreed, that makes much more sense. We never got pulled to the printout at Finger Lakes though. I was surprised that this wasn't standardized between different regional, but how can the cylinder not be measured the same way within a regional?
__________________
What are nationals? Sounds like a fun American party, can we Canadians come?
“For me, insanity is super sanity. The normal is psychotic. Normal means lack of imagination, lack of creativity.” -Jean Dubuffet
"Insanity is doing the same thing over and over again and expecting different results." -Albert Einstein
FLL 2011-2015 Glen Ames Robotics-Student, Mentor
FRC 2012-2013 Team 907-Scouting Lead, Strategy Lead, Human Player, Driver
FRC 2014-2015 Team 1310-Mechanical, Electrical, Drive Captain
FRC 2011-xxxx Volunteer
How I came to be a FIRSTer
 <Since 2011
|