Quote:
Originally Posted by John_1102
Several things I noticed about 832...
The front end of their shooter stuck out over the frame perimeter even after they taped the cylinder up.
The wall they attached to the shooter had to stay <=60" before the match started was the other problem.
They taped the cylinder because they didn't have time to reprogram it to start out the match with the cylinder fully extended...I think.
|
Here is what I understand to be the case (if someone from 832 can comment or correct, go ahead).
They added a panel at ~60" high to play defense. It was finished as the timer went off. They had to place the bot on the field immediately. Since there was no time remaining, they were not allowed to pre-charge their pneumatic system. Without air pressure, their shooter could not be elevated. Since it was not elevated, it stuck out beyond the frame perimeter.