[roystur44]

We used the Vexpro shafts on our manipulators. The .500 hex shaft is the bomb as well as the .500 round shaft. The dimensions are spot on and the pricing is great. Hope the prices stay the same.

The shaft collars worked out great as well as the bearings. The hexed bearings were out of stock so that hampered our design a bit.

The website was easy to order from and the CAD of the products where available to include in our CAD.

I would love to see a adjustable slip/magnet clutch included in the products. Being able to adjust the torque to a gripper or ball magnet mechanism is such a time consuming process.

I would also love to see some high powered servo's so we can build gimble, aiming and trigger mechanisms easily.

We used the 2013 KOP chassis. I would love to see a picture of the Ball shifters on a 2013 setup with belts and pulleys. Even better if it had 1.5" Traction wheels.

Two thumbs up for VexPro!