View Single Post
  #11   Spotlight this post!  
Unread 02-04-2013, 22:22
tribologist tribologist is offline
Registered User
FRC #0177
 
Join Date: Apr 2013
Location: United States
Posts: 1
tribologist is on a distinguished road
Re: VEXPro Ball Shifter Shaft Malfunction

Quote:
Originally Posted by Nemo View Post
Has anybody intentionally removed these press-fit shafts in order to install longer hex shafts?
It is very easy to remove. The anodization, left over schmutz and grease makes it a week bond. Clamp the shaft in a vise and tap it off with a brass drift (or that screw driver you don't like).

When you make the new shaft you need to drill out a hole at the end so that the spool is not blocked. Measure the hole on the old shaft.

Use Loctite 603 and be very careful to clean everything before bonding. You are best off lubricating after assembly.

Ulf