Quote:
Originally Posted by Bstep
How constrained did you make it? You said that a 2" opening didn't go straight enough so that you made it a smaller opening. Did you make it as small as 1.5" or closer to 1.75"?
|
I'd have to measure to be sure, but it was pretty close to 1.625. We machined 1/2" delrin stock down, adding a taper to the loading end, and placed it on the top wall of our shooter. One stick close to the wheel side, one stick close to the wall side. The main effect was getting rid of our height variation but the curve disappeared too.