Thread: Hardware Questions
View Single Post
  #8   Spotlight this post!  
Unread 02-05-2013, 17:41
Dad1279 Dad1279 is offline
Registered User
FRC #1279 (Cold Fusion)
Team Role: Mentor
  
Join Date: Jan 2005
Rookie Year: 2004
Location: NJ
Posts: 511
Dad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud of
Re: Hardware Questions
If they are short, McMaster has threaded hex standoffs, in aluminum & steel. Then you could use a bearing on a bolt threaded into the standoff. Not cheap or easy, but no machining.

http://www.chiefdelphi.com/forums/ne...te=1&p=1271391