View Single Post
  #41   Spotlight this post!  
Unread 03-06-2013, 10:22
Teamcodeorange's Avatar
Teamcodeorange Teamcodeorange is offline
Registered User
FRC #3476
 
Join Date: Jan 2011
Location: US
Posts: 236
Teamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant futureTeamcodeorange has a brilliant future
Re: What Drivetrain?

Quote:
Originally Posted by Tom Line View Post
Yes. We destroyed probably a half dozen bearings in a non-loaded low speed application. We ended up not using that particular mechanism on the robot. However, the incidents of failure left us with a very low opinion of the current generation of hex-bearings.

Our application was single shaft non-cantilevered (supported by bearings at both ends). The bearings blew out sideways after the races cracked.
Same as us. Bad bearings, don't do that.
__________________
Try Code Orange's electronics tutorials!
---------------------------------------------------------
2015 - Tesla Division Champions
2015 - Inland Empire Engineering Inspiration Award
2015 - San Diego Regional Chairman's Award
2014 - San Diego Regional Chairman's Award
2013 - Newton Division Champions
2012 - San Diego Regional Winners
Reply With Quote