Quote:
|
You can keep this design constraint and still use cheaper round bearings if you use this AndyMark part for your idler shafts.
|
Thanks Chris for your comment. That particular part is too small because the gearbox is nominally 2 inches wide. Andy Mark does also sell the SS Cluster Shaft (am-0536) which is close with a HEX length of 1.895 inches and the overall length of 2.295 inches, but a little short (0.395/2) on bearing support on both ends. The overall length should be perhaps a half inch longer to have full bearing support on both sides. I'll see if I can get a couple pieces made and re-evaluate the design.