Quote:
Originally posted by Jim Smith
We are just using a tie wrap around the drill gearbox body to keep the slider in low. Although as I think about it, there may be some "tie wrap use" rule that I need to go back and check.
|
We are using a tie wrap also. It seems to be a very good fit just below the gear shift. As for a "tie wrap use rule", we used a mass of them last year, and I haven't run across any rule against them so far in this year's manual.
__________________
FIRST Team 980, The ThunderBots
2002: S. California Rookie All Stars
2004: S. California: Regional Champion,
Championship Event: Galileo 2nd seed,
IRI: Competition Winner, Cal Games: Competition Winner
2005: Arizona: 1st seed
Silicon Valley: Regional Champion (Thanks Teams 254 and 22)
S. California: Regional Runners Up (Thanks Teams 22 and 968)
|