Thread: pic: Introducing BarBox: My First Attempt at Gearbox Design
View Single Post
  #12   Spotlight this post!  
Unread 27-07-2013, 01:07
Adrian Clark Adrian Clark is offline
Registered User
FRC #1678 (Citrus Circuits)
Team Role: Mentor
  
Join Date: Apr 2012
Rookie Year: 2009
Location: United States
Posts: 79
Adrian Clark is a jewel in the roughAdrian Clark is a jewel in the roughAdrian Clark is a jewel in the roughAdrian Clark is a jewel in the rough
Re: pic: Introducing BarBox: My First Attempt at Gearbox Design
Quote:
Originally Posted by bardd View Post
The output shaft sits on two different bearing sizes (0.875" in the back and 1.125" in the front)
Why is this necessary?

And a note on standoffs: It's very hard to find .375 OD tube with #10 clearance ID. Rather than buying .375 rod and drilling it out I prefer to buy .0625 wall with .375 OD and put .0625 deep counterbores in the plates to capture the standoff. Makes things much lighter and simpler to make.
Last edited by Adrian Clark : 27-07-2013 at 01:16.
Reply With Quote