View Single Post
  #13   Spotlight this post!  
Unread 01-08-2013, 11:08
jwallace15's Avatar
jwallace15 jwallace15 is offline
What am I going to do with my life?
AKA: Wally
FRC #0068 (Truck Town Thunder)
Team Role: College Student
 
Join Date: Aug 2012
Rookie Year: 2013
Location: Michigan
Posts: 435
jwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud ofjwallace15 has much to be proud of
Re: Arduino + Ethernet Shield Help

Quote:
Originally Posted by BornaE View Post
Back to the code, what do you get printed on the serial port when you press the buttons?
Allow me to test (it did say something I just can't remember)

...

Alright testing now.

Accessed the webpage, serial printed...

Code:
 HTTP
favicon.i,,
Pressing "On"

Prints the same. No LED.

Pressing "Off"

Same thing. And no LED.

When I press the buttons, the TX and RX leds blink on both the ethernet shield and the R3, and an LED I connected to pin 13 (it is not in the code though, it's just there to show me if the Arduino LED blinks) gets a little bit brighter when the TX and RX leds blink.
__________________
J Wallace IV
Truck Town Thunder
Just a college student now.

Last edited by jwallace15 : 01-08-2013 at 11:14.