Quote:
Originally Posted by Mark McLeod
One of the tools that FIRST gave us this season is the 2013 FRC Bridge Configuration Utility If you already have it, then a shortcut was probably added to your desktop.
Just connect the DLink to your laptop via Ethernet, run the utility and follow directions. |
You might have to do a hard reset of the bridge.
Quote:
|
Originally Posted by Bridge Manual
To reset the access point, locate the reset button (hole) on the rear panel of the unit. With the access point powered on, use a paperclip to hold the button down for 10 seconds. Release the button and the access point will go through its reboot process. Wait about 30 seconds to access the access point.
|
Make sure the bridge is powered on completely. It can brick if you don't wait to reset it.