Quote:
Originally Posted by pigpenguin
Confused on servo power, due to lack of jumpers and everything. Is it software defined some how? Or will we need a separate board to run servos?
|
FRC speed controllers don't connect the power pin to anything, odds are that they just routed 6v to the power pin on all of the PWM pins.
Quote:
Originally Posted by Peter Johnson
Can anyone identify the connector being used for CAN bus? It almost looks like it only has two pins.. where are the +5V and ground pins?
|
The CAN connector looks a lot like the power connector on the 2CAN. Probably just the two wires. As a differential bus CAN shouldn't need the 5V and GND being passed around.