Thread: Urethane Wheels Run off Cim Motor
View Single Post
  #13   Spotlight this post!  
Unread 13-08-2013, 11:24
Lil' Lavery Lil' Lavery is offline
TSIMFD
AKA: Sean Lavery
FRC #1712 (DAWGMA)
Team Role: Mentor
  
Join Date: Nov 2003
Rookie Year: 2003
Location: Philadelphia, PA
Posts: 6,607
Lil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond repute
Send a message via AIM to Lil' Lavery
Re: Urethane Wheels Run off Cim Motor
Quote:
Originally Posted by LedLover96 View Post
My other question, why broach for a key instead of just broaching hex?
A) Because the OP was asking how to interface these wheels directly with a CIM/Mini-CIM.
B) Because not everyone uses hex shaft