Thread: WCD-Belt Driven CAD practice
View Single Post
  #9   Spotlight this post!  
Unread 18-08-2013, 22:18
Mk.32's Avatar
Mk.32 Mk.32 is offline
Registered User
AKA: Mark
FRC #2485 (W.A.R. Lords)
Team Role: Engineer
  
Join Date: Jan 2011
Rookie Year: 2011
Location: San Diego
Posts: 770
Mk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud of
Re: WCD-Belt Driven CAD practice
Quote:
Originally Posted by Cash4587 View Post
http://prntscr.com/1m25qt

Yet again, I did some more updating to make the bumper mounts legal (the distance between them was not <= 8in.) and I made their flanges beefier. Lastly, I widened the frame an inch and a half on each of the end tubes to better use all of the frame perimeter rule except 1 inch of it. so the frame perimeter is now 111" vs 108"
We did the almost did the same thing, belt drive WCD with WCP gearboxes.

We were able to fit 9mm GT2 pulleys in there no problem.
http://31.media.tumblr.com/624ace34b...cgvo7_1280.jpg I personally machined the pulleys out of 3/8 alum plate.
__________________
Engineering mentor: Team 2485: WARLords 2013-

Team President: Team 3647 2010-2013
Reply With Quote