Thread: Stepper Driver to CIM
View Single Post
  #10   Spotlight this post!  
Unread 19-08-2013, 00:57
daniel_dsouza daniel_dsouza is offline
does what needs to be done.
FRC #2449 (Out of Orbit Robotics)
Team Role: Alumni
  
Join Date: May 2011
Rookie Year: 2011
Location: Chandler, AZ
Posts: 231
daniel_dsouza has a spectacular aura aboutdaniel_dsouza has a spectacular aura about
Re: Stepper Driver to CIM
So say that you do decide to use CIMS...

What would your electronics setup look like. Do you have a specific set of encoders in mind? What board will interface between the motors and PC CAM software?

There was someone who used CIM motors to make a 3D printer that printed concrete...That was some time back.

Your posts are like poetry...take it or leave it.