|
Re: LabVIEW, have throttle run motor?
Thanks that looks good. I,ll try it and see. The only other thing I was worried about with this section of the code was if the axis 3's output numbers were 0-1 or not and if I needed to put an algorithm in between the axis 3 output and the set motor input so set motor did the right thing with it.
__________________
---------------------
Alumni, CAD Designer, machinist, and Mentor: FRC Team #4080
Mentor: Rookie FTC Team "EVE" #10458, FRC Team "Drewbotics" #5812
#banthebag
#RIBMEATS
#1620
|