View Single Post
  #36   Spotlight this post!  
Unread 15-10-2013, 19:14
R.C.'s Avatar
R.C. R.C. is offline
2017... Oooh Kill em, Swerve!
AKA: Owner, WestCoast Products
FRC #1323 (MadTown Robotics)
Team Role: Engineer
 
Join Date: Feb 2008
Rookie Year: 2006
Location: Madera, CA
Posts: 2,186
R.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond repute
Re: Show off your machining!

Quote:
Originally Posted by Akash Rastogi View Post
Was going to ask this as well. It looked as if they were tumbled afterwards.
I doubt they are tumbled (finish isn't dull), I'd go with a really nice face mill (2" or larger) with a very light pass for surfacing.

But Cory would know!

-RC
__________________
R.C.
Owner, WestCoast Products || Twitter
MadTown Robotics Team 1323

Last edited by R.C. : 15-10-2013 at 19:48.