Thread: Power Distribution Board Question
View Single Post
  #1   Spotlight this post!  
Unread 18-11-2013, 15:28
Jason Spurlock Jason Spurlock is offline
Registered User
FRC #0313
  
Join Date: Nov 2013
Location: Michigan
Posts: 1
Jason Spurlock is an unknown quantity at this point
Power Distribution Board Question
Hi, I'm a mentor from Team 313 - The Bionic Zebras, and now I'm participating in a college robotics club and we want to use the FIRST power distribution board, but the robot we want to build has motors that run off of 24 volts. What would happen if we put 24 volts through the power distribution board? The spec sheet for the power distribution board says that it can take 6-15 Volts. We do not know why there is a operating voltage range because we are assuming all the grounds are internally connected and all the positive power is internally connected so voltage should not matter, right?