Thread: Solenoid Break Out Power Help
View Single Post
  #1   Spotlight this post!  
Unread 18-11-2013, 20:47
gsesny gsesny is offline
Registered User
FRC #5804 (Torch 5804)
Team Role: Mentor
  
Join Date: Nov 2013
Rookie Year: 2013
Location: Richmond, VA
Posts: 19
gsesny is an unknown quantity at this point
Solenoid Break Out Power Help
Hey,

I could use a little help with powering a solenoid break out. I have followed all of the instructions and done quite a bit of research. I have connected my breakout to the PDB with a 20 amp breaker and then to a Wago and onto the Breakout. I do not see any light from a Power LED. I do see the LED on the solenoid block that toggles between two different solenoids. I used a multimeter to test the power and we have nothing going into breakout. I have tried a new breakout and that didn't work either. Any suggestions