|
Re: What materials do you most commonly use on your robots?
Quote:
Originally Posted by MichaelBick
Your original statement was that 8020 is a "terrible" material. My primary point is that this is obviously not the case, because a robot that was mostly built out of 8020 did so INSANELY well.
|
The best robot I've ever worked on (449's bot for Overdrive) was made mainly out of 80/20. This does not offset the fact that by far the single largest source of mechanical failures I have witnessed on our robots, both directly and indirectly, has been 80/20 construction. I have not seen those same mistakes made with tube/gusset construction, simply because the modes of failure I've seen most often are simply not possible with tube/gusset construction.
__________________
"Mmmmm, chain grease and aluminum shavings..."
"The breakfast of champions!"
Member, FRC Team 449: 2007-2010
Drive Mechanics Lead, FRC Team 449: 2009-2010
Alumnus/Technical Mentor, FRC Team 449: 2010-Present
Lead Technical Mentor, FRC Team 4464: 2012-2015
Technical Mentor, FRC Team 5830: 2015-2016
|