|
Re: Practical 3D printed parts
I'm currently, with the aid of some members of 449, checking out the feasibility of printing GT2 pulleys, which would be a huge cost-saving measure and allow a lot of flexibility over COTS aluminum pulleys. I'll report back on how it goes, if you'd like.
__________________
"Mmmmm, chain grease and aluminum shavings..."
"The breakfast of champions!"
Member, FRC Team 449: 2007-2010
Drive Mechanics Lead, FRC Team 449: 2009-2010
Alumnus/Technical Mentor, FRC Team 449: 2010-Present
Lead Technical Mentor, FRC Team 4464: 2012-2015
Technical Mentor, FRC Team 5830: 2015-2016
|