Quote:
Originally Posted by techhelpbb
That's interesting because that differs from a conference call myself and others had with MakerBot and specifically MakerBot support in relation to a MakerBot 2X. When we mentioned that someone was using it to print PLA they suggested it was ill suited for that because it tends to get too hot. The issue is that if you print PLA and have issues will they provide support and if something happens while printing PLA will the accept it under MakerCare in the event replacement parts are required.
I can't speak to nylon never tried it in that printer. I'm sure their PVA works I've used that before.
|
Seems to me that piece of information would be in the user manual… rather than troubleshooting steps for printing with PLA (
http://downloads.makerbot.com/replic...Manual_Eng.pdf See page 97)