|
Re: 2CAN: not detecting CAN traffic
Remember when switching from serial based CAN to the 2CAN, you have to go into the Imaging Tool and select the 2CAN plugin and select "Apply" (you do not need to reformat the controller). This will load the correct plugin to let the controller talk to the 2CAN.
I believe that the Imaging Tool loads with the 2CAN plugin by default, be sure to click apply just to make sure and power cycle the entire robot. I'd also make sure you have a termination resistor at the end of the chain.
__________________
I'm right 90% of the time, so why worry about the other 3%?
Last edited by Cecil : 05-12-2013 at 20:54.
Reason: Misunderstood the post
|