Quote:
Originally Posted by Bald & Bearded
All:
Attached is a portion of a presentation I gave at the FRC Workshops sponsored by Team 1418 this past Saturday.
The core of the charts are #6,7,and 8 which are some comparisons of the printers being offered in FIRST Choice, some highly reviewed printers from Make magazines 3d printer issue, and some information on kits I am familiar with.
The key is teams need to do an ROI and value analysis before they jump on this technology.
|
Thanks I like the effort put into the comparison.
I am not sure one actually needs to have dual Z motors as a "critical feature" (page 4) as long as they can achieve the resolution and movement with one: does it really matter?
After all: often times the dual Z stepper motors are in parallel (with respect to a RAMPS 1.4 system for example...not in the general sense of stepper motor windings) and you are actually sending less power to both motors. For something like a Prusa I3 it makes sense because the dual Z lifts the carriage over the width of the printer. In a design like the MakerBot, Duplicator 4, or others of that type the table moves the print in the Z axis of the printer instead of the potentially heavier head assembly. Keeping in mind the head assembly moves in the X from side to side so at any one time the increased weight of the head is on one side of the other of the Prusa I3 design. That issue does not exist in the other design: the prints weigh less and really should not extend over the bed, while the extruder may extend out over the bed surface increasing the leverage of the head weight in the Prusa I3 system.