[RonnieS]

Originally Posted by Sparky3D

I'm hoping that Vex/WCP will elaborate on this as well. After looking at the pictures and release video, it looks like they drilled holes in the sides of the frame rails and face mounted them, but I'm hoping there's more to it than that. Trying to get the mounting holes properly aligned with just "a saw and a drill" would be rather difficult.

That is where I was getting at. They said a drill and wrench so we might have to wait till the manual is published to see what they have planned. For a lot of teams that would be rather difficult but the good part is that hopefully as long as you can get it fairly square and the flush mount on the face of the shifters to the 1x2 face then the versa blocks will automatically put your sprockets in line and allow you to still have a decent drive line. That is if they designed them to be offset the same...I assume they did