Quote:
Originally Posted by Richard Wallace
The square configuration I was suggesting is not symmetrical fore-and-aft. I was thinking to get a (nearly) square chassis by cutting the side rails 2567 and 2572 on one end only. The resulting configuration has two wheelbases; one about 8.76 inch from the center wheel via the 131 tooth belt, and the other about 12.6 inch from the center wheel via the 170 tooth belt. Axle holes for the shorter span are at the same rail level as the center wheel (no drop), and those for the longer span are raised about 1/8" -- the result is a chassis that can tip just a bit on the center wheels, effectively a slight drop.
|
I'm sorry but we haven't got a chance to look at this in CAD yet but has anyone looked at making a square chassis by cutting ~2" off each end. I am sure this will require new belts but are the front/rear axle holes available for this. This keeps the front and rear wheebase the same.