Thread: Pneumatics NOT Working - Help - Pictures included
View Single Post
  #6   Spotlight this post!  
Unread 09-01-2014, 10:27
Mark McLeod's Avatar
Mark McLeod Mark McLeod is offline
Just Itinerant
AKA: Hey dad...Father...MARK
FRC #0358 (Robotic Eagles)
Team Role: Engineer
  
Join Date: Mar 2003
Rookie Year: 2002
Location: Hauppauge, Long Island, NY
Posts: 8,820
Mark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond repute
Re: Pneumatics NOT Working - Help - Pictures included
Umm, you appear to have plugged your PWM cable leading to the Spike into a motor speed controller/servo output rather than the proper RELAY output.
If that one PWM cable on a Relay connection is from your Spike, then according to your code the Spike needs to be connected to Relay 1.
The proper connection pins are a couple of millimeters to the right of the Relay LED that is glowing. Those LEDs are side by side with the pins that are firing.

http://www.chiefdelphi.com/forums/at...1&d=1367246283
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 10-01-2014 at 08:24.