|
Re: Motor Controllers
At a quick glance, the code looks fine. Check to make sure that the 4 talons are plugged into the correct ports and are plugged in correctly. Also check in the driver station that the joysticks are in the first 2 slots in the setup tab.
Additional information, when you enable are the lights on all 4 Talons going solid to show that they have communication?
When you move the joysticks, are all 4 Talons flashing red or green to show they are trying to move?
Last edited by notmattlythgoe : 09-01-2014 at 13:09.
|