Thread: CRio II will not communicate
View Single Post
  #5   Spotlight this post!  
Unread 14-01-2014, 09:02
1024Programming 1024Programming is offline
Registered User
FRC #1024
  
Join Date: Jan 2014
Location: Indiana
Posts: 43
1024Programming is an unknown quantity at this point
Re: CRio II will not communicate
Quote:
Originally Posted by DDSLoan96 View Post
When you are imaging the cRIO dont connect through the router, just connect straight into the cRIO Ethernet port. Not sure exactly why but the signal that the cRIO rebooted gets lost sometimes with the router. I just had this same issue over the past 2 days
Yes, we tried this too before losing communication with the CRio. It resulted in the same state of waiting for the CRio to reboot. The troubleshooting guides say to avoid this you should go through a router. So, that is what we did, had the same problem and then it was compounded by the additional inability to communicate with the CRio.

So, until we find a way to restore communication with the CRio, imaging it has been taken off the table

Thanks!!