|
Re: 2073 Pneumatic Catapult
Quote:
Originally Posted by buildmaster5000
What are the specs on the cylinder? Specifically bore and stroke length...
|
Really good question!
After trying a Bimba 178 (1.5"dia. X 10" stroke) we found we just didn't have enough height or distance out of our system. We run it at 60 psi which produces 106 Lb. of force.
So, our next thought was that the force was sufficient, but we needed more speed out of the cylinders. So, to maintain the force, we substituted in two Bimba 0910 (1 1/16"dia X 10" stroke). This yields the same 106 Lb. of force at 60 psi, and moves a lot faster.
An additional note here is that we are using low pressure storage tanks between the valve and cylinder. One per cylinder. This is done to maximize air flow to the cylinder by not restricting it as it flows through the valve.
__________________
CalGames 2009 Autonomous Champion Award winner
Sacramento 2010 Creativity in Design winner, Sacramento 2010 Quarter finalist
2011 Sacramento Finalist, 2011 Madtown Engineering Inspiration Award.
2012 Sacramento Semi-Finals, 2012 Sacramento Innovation in Control Award, 2012 SVR Judges Award.
2012 CalGames Autonomous Challenge Award winner ($$$).
2014 2X Rockwell Automation: Innovation in Control Award (CVR and SAC). Curie Division Gracious Professionalism Award.
2014 Capital City Classic Winner AND Runner Up. Madtown Throwdown: Runner up.
2015 Innovation in Control Award, Sacramento.
2016 Chezy Champs Finalist, 2016 MTTD Finalist
|