|
Re: 2073 Pneumatic Catapult
Quote:
Originally Posted by seg9585
Fascinating, I never thought of doing it this way. I want to try this now (I'll give you credit, hah).
I assume the tubing diagram would look like this:
Compressor --> Upstream Accumulator (115 psi) --> Regulator --> Valve --> Downstream Accumulator (60 psi) --> Cylinder
T-junction connecting both the downstream accumulator and cylinder to the valve......
|
Absolutely correct!
One note:
To maximize the air flow from the downstream accumulators to the cylinders, use double ended accumulators and feed into one end, putting the "T" between the valves and accumulators, then run the hose from a straight fitting on the other end of the accumulator into the cylinder, also with a straight fitting. Avoid using the 90deg fittings if possible.
__________________
CalGames 2009 Autonomous Champion Award winner
Sacramento 2010 Creativity in Design winner, Sacramento 2010 Quarter finalist
2011 Sacramento Finalist, 2011 Madtown Engineering Inspiration Award.
2012 Sacramento Semi-Finals, 2012 Sacramento Innovation in Control Award, 2012 SVR Judges Award.
2012 CalGames Autonomous Challenge Award winner ($$$).
2014 2X Rockwell Automation: Innovation in Control Award (CVR and SAC). Curie Division Gracious Professionalism Award.
2014 Capital City Classic Winner AND Runner Up. Madtown Throwdown: Runner up.
2015 Innovation in Control Award, Sacramento.
2016 Chezy Champs Finalist, 2016 MTTD Finalist
|