|
Re: Powering Arduino
We used 6v from the servo power supply through Arduino's vin.
You can use the PD board 5v supply if you would like:
Quote:
R36
All circuits, with the exceptions of those listed in R42 and R45, must connect to, and have power sourced solely by, a single protected 12VDC WAGO connector pair (i.e. the Load Terminals, as shown in Figure 4-11) or the 5VDC supply on the PD Board (as shown in Figure 4-12), not the M6 shanks.
|
You can't use the cRio or radio supply though.
__________________
Kettering University - Computer Engineering
Kettering Motorsports
Williams International - Commercial Engines - Controls and Accessories
FRC 33 - The Killer Bees - 2009-2012 Student, 2013-2014 Advisor
VEX IQ 3333 - The Bumble Bees - 2014+ Mentor
"Sometimes, the elegant implementation is a function. Not a method. Not a class. Not a framework. Just a function." ~ John Carmack
|