Quote:
Originally Posted by Chris is me
Just something to be aware of - hex stock from sources other than VexPro tend to run oversized. You will probably need to do some machining to get these shafts to fit through bearings and even some broached parts...
|
Good point Chris. Always look at the specs on shafts.
Temper
0 (Annealed) <-- machinable
Width 1/2 inches
Width Tolerance
+0/-0.004 inches <-- will determine fit to hole
Overall Length 36 inches
Length Tolerance +0.032/-0 inches
Indentation Hardness 83 Rockwell B
Tensile Strength Max 89900 PSI