[zeldathegood]

We are having the same issue as stated in the original post.

We got a new CRIO and the 3 modules this year on the FIRST choice. We have been trying to image the CRIO but when we bring up the imaging tool or rescan it is not showing the modules in the picture on the right. That means that the toggle switches on the bottom are disabled so when we try to image we get an error regarding IP Address.

We have tried all the trouble shooting ideas I have found in numerous spots on chief delphi and this forum but nothing seems to work.
1. We tried with and without the router between the computer and the CRIO
2. We set our mask to 255.255.255.0
3. We tried multiple different IP addresses on the computer. 10.XX.YY.5 where xxyy is our team number. We also matched the ip address of the crio with the last number different.
4. We are able to ping the CRIO using it's IP address
5. We also turned off the firewall

Does anyone have any ideas? Could we have gotten a bad CRIO?

We have our old CRIO and we were able to bring up the imaging tool fine using the same computer. We can see the all the modules on that device. We did try the old modules one by one in the new CRIO and they are still not recognized so we don't feel it is the modules.

Please help.

Thanks in advance. We are going crazy.