|
Re: CAM Pocketing/Contouring Methods
Quote:
Originally Posted by Cory
My defaults for a 1/4" 3 flute tool in 1/4" aluminum are 40% radial cut width at full depth when pocketing. You should be able to do the same, albeit at a lower feed since you have a slow max spindle speed. The main limiting factor here is ability to clear chips so you are not recutting them.
|
Perfect. Do you spiral through the material? If so, what ramp angle do you use?
__________________
2015 Newton Semi-Finalist (3130, 2468, 3310, 537)
2015 Lubbock Regional Winner (2468, 3310, 4799)
2014 Galileo Quarter-Finalist (2052, 70, 3310, 3360)
2014 Colorado Regional Winner (1138, 3310, 2543)
2013 Texas Robot Roundup Winner (3310, 624, 2848)
2013 Archimedes Semi-Finalist (126, 3310, 1756)
2013 Dallas Regional Winner (148, 3310, 4610)
2012 Dallas West Regional Winner (935, 3310, 4206)
|