Thread: Talons flash red on enable
View Single Post
  #3   Spotlight this post!  
Unread 23-01-2014, 21:54
raptaconehs raptaconehs is offline
Registered User
FRC #3200
  
Join Date: Dec 2013
Location: Colorado
Posts: 54
raptaconehs will become famous soon enoughraptaconehs will become famous soon enough
Re: Talons flash red on enable
Quote:
Originally Posted by DDSLoan96 View Post
Today we were planning on having the robot running around but we have hit a bit of a snag. When we enable our robot all of our Talons flash Red which means there is a fault. The only thing we see in the Talon manual is that it could be either low input voltage(checked we get 12 volts at each), over temperature(Cold to the touch) or a shorted output transistor. What can I do to fix this
It just means that the Talons haven't been configured yet. Once you configure them you will see that they will go to a solid orange state on enable.