Thread: VexPro WCD VersaChassis Hex Shaft?
View Single Post
  #5   Spotlight this post!  
Unread 24-01-2014, 23:52
R.C.'s Avatar
R.C. R.C. is offline
2017... Oooh Kill em, Swerve!
AKA: Owner, WestCoast Products
FRC #1323 (MadTown Robotics)
Team Role: Engineer
  
Join Date: Feb 2008
Rookie Year: 2006
Location: Madera, CA
Posts: 2,179
R.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond repute
Re: VexPro WCD VersaChassis Hex Shaft?
Quote:
Originally Posted by ksafin View Post
How deep is the 1/4-20 tap? (read: how much can we cut it and retain the tap?)
http://www.vexrobotics.com/vexpro/we...sachassis.html

Under Drawing:

http://content.vexrobotics.com/vexpr...awing-Rev2.PDF

Its tapped about 1.5" deep, it should work for almost any wheel configuration. You can also drill deeper if needed.
__________________
R.C.
Owner, WestCoast Products || Twitter
MadTown Robotics Team 1323