Quote:
Originally Posted by peronis
The digital module is plugged into module 2 on the 4 slot crio. The code uploads fine, and the status light is blinking normally until we run the code.
|
As described at the site below, the digital module in slot 2 is the first digital module and should be referenced as module 1.
http://wpilib.screenstepslive.com/s/...-and-variables
Quote:
Originally Posted by peronis
Then the 5V indicator on the digital sidecar and the status light both go out when we enable the robot.
|
This indicates a problem with the power to the digital sidecar. Make sure it is connected to a 20 amp breaker in the PDB.