|
Re: festo valve wiring help
If I remember correctly the pin spacing is off from a standard pwm cable but the pin sizes are approximately the right size.
If that is the case, take a 3 pin pwm cable, remove the center pin and cut down the middle. Plug the individual pins into the solenoid.
Reinsert the pins on the other side to a 2 pin housing of course.
__________________
Kevin Li
596 - Sciclones
1405 - Finney Falcons
2262 - Holliston Panthers
Last edited by kevin.li.rit : 27-01-2014 at 16:43.
|