[xXhunter47Xx]

Previous question resolved. New question: When we slide to the right, the voltage drops to below 9 volts and kills the robot. This only happens when we try to strafe/run diagonally right.
This was a problem on the Ultimate Ascent robot we built except it was to the left instead. We haven't figured out the problem for this yet.
Is it a coding problem?
Or a wiring problem?



Previous question resolved, new one now, the cRIO wipes the code every time we do a power cycle.
We've checked the little box during imaging for labview, and it doesn't keep the code.
In LabView, we are trying to invert the motors and it would give me the problem attached.