View Single Post
  #2   Spotlight this post!  
Unread 27-01-2014, 21:47
wt200999's Avatar
wt200999 wt200999 is offline
Texas Instruments
AKA: Will Toth
FRC #3005 (Robochargers)
Team Role: Mentor
 
Join Date: Mar 2006
Rookie Year: 2004
Location: Dallas, Texas
Posts: 323
wt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud ofwt200999 has much to be proud of
Send a message via MSN to wt200999
Re: RS232 Serial Bridge not working on Firmware 107?

It sounds like you are able to receive a message on each of the black jaguars, but it just doesn't pass it along.

We had a similar problem with a team here, and it turned out the middle pins on the RJ-12 connector where stuck depressed in and not springing back, so the CAN cable was not making contact. So the BDC-COMM tool could see the first jaguar in the chain, but not the rest. The only way we were able to fix this was to replace the outgoing RJ-12 connectors.

I would recommend looking in at the actual pins on both the input and output side for each of the jaguars and see if this is your problem.