Thread: VexPro VersaBlock center-wheel drop
View Single Post
  #10   Spotlight this post!  
Unread 28-01-2014, 22:17
R.C.'s Avatar
R.C. R.C. is offline
2017... Oooh Kill em, Swerve!
AKA: Owner, WestCoast Products
FRC #1323 (MadTown Robotics)
Team Role: Engineer
  
Join Date: Feb 2008
Rookie Year: 2006
Location: Madera, CA
Posts: 2,179
R.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond repute
Re: VexPro VersaBlock center-wheel drop
Quote:
Originally Posted by ksafin View Post
Fantastic. One more question - what's the proper means of attaching the CAMs?
On this Page:

http://www.vexrobotics.com/catalog/p...lery/id/26220/

http://www.vexrobotics.com/vexpro/we...gblocks-g.html

The picture above should show it, all you do is mount the cam dead center. Put a #10 hole through both sides of the tube. Thread a #10-32 bolt into the cam, don't fully tighten.

Make sure the bearing block/VersaBlock can slide by hand, then just rotate the CAM. The CAM will push the block away from it and tighten the piece of chain/belt. Then just tighten the VersaBlock/Bearing Block & CAM. That's about it.
__________________
R.C.
Owner, WestCoast Products || Twitter
MadTown Robotics Team 1323