Thread: WCP DS three cim west coast help
View Single Post
  #8   Spotlight this post!  
Unread 31-01-2014, 12:07
Arpan Arpan is offline
Olin class of 2019
FRC #3061 (Huskie Robotics)
Team Role: Alumni
  
Join Date: Feb 2012
Rookie Year: 2011
Location: Naperville
Posts: 169
Arpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud ofArpan has much to be proud of
Re: WCP DS three cim west coast help
Quote:
Originally Posted by KrazyCarl92 View Post
The output shaft should be retained in the axial direction by a snap ring on the input side of the motor plate (keeps the shaft from moving toward the output direction) and a 1/2" round to 5/8" hex shoulder with a dog gear in place right up against the output side of the motor plate (keeps the shaft from moving away from the output direction). Ours is assembled this way and the output shaft is properly retained.
Hrmm. Perhaps I'm a bit confused, but is the shoulder already in the shaft?
Do you have a picture you could upload?