Quote:
Originally Posted by Alan Anderson
In the LabVIEW project, do you have the target IP address set to 10.3.57.2, or is it 10.03.57.2? I've found that having a leading zero can confuse the networking sometimes.
|
Yes it is setup as 10.3.57.2.
Something else I forgot to add was that in the tele-op vi (where the drive code is), I gave a constant of zero to both sides and the side that moved without joystick command, moved. I moved the joystick axis and the other side did not move. I know that my coding is not wrong on the surface, but I don't know how in the world is this happening.