Quote:
Originally Posted by Tristan Lall
Can you list your process parameters? (Things like filler alloy and thickness, base alloy and thickness, gas cup type and size, torch size, electrode type, size and point, current, voltage type and effect, gas mix and pre/post/welding flow, machine type, size, input voltage and duty cycle, joint preparation and position, etc..)
We might benefit from a thread about welding practices, material selection and post-weld heat treatment.
|
We used a Miller Diversion 180. 100% argon, and made sure the aluminum was really clean. That seems to be the key for aluminum. Used a stainless steel brush to mechanically clean the joints.
The Diversion 180 makes it easy, has presets for steel and aluminum. The only place where a bigger machine would have been nice is getting deep into corners and being able to change the frequency to drive th arc some more.
6061 aluminum, and 4043 (I think) filler. 3/32 tungsten and the cup for that size. Did not use a gas lens, but understand that can help. Part of the future practice sessions.
Mistakes made. Welded too much at once and heat warped the parts. Keep track of how much heat and take it slow. May mean restarting some beads part way through. Work far apart to minimize the heat.
The diversion is a good dual voltage unit as well. 120, and 240 with the change of a plug, just limits the upper end of the amperage provided. It is very light and easy to move as well.