Thread: PDB question for Inspectors
View Single Post
  #1   Spotlight this post!  
Unread 10-02-2014, 00:57
philso philso is offline
Mentor
FRC #2587
  
Join Date: Jan 2011
Rookie Year: 2011
Location: Houston, Tx
Posts: 938
philso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond reputephilso has a reputation beyond repute
PDB question for Inspectors
This is a question for those of you who work as inspectors.

We have a tightly packed electronics panel. There is about a one inch gap between the power distribution board and a line of 4-5 motor controllers installed on each side. We have a bundle of PWM wires running through that gap that can obscure the LED's along the sides of the PDB from being viewed directly. If one of the LED's is on, we can still see a red glow between the wires. Would this pass inspection or should we re-route the wires now while we still can? The power wires to and from the motor controllers and the snap-action breakers are all clearly visible.

I can post a picture tomorrow evening if necessary.

Thanks.

Phil